Lieber Besucher, herzlich willkommen bei: Snes-Projects.de. Falls dies Ihr erster Besuch auf dieser Seite ist, lesen Sie sich bitte die Hilfe durch. Dort wird Ihnen die Bedienung dieser Seite näher erläutert. Darüber hinaus sollten Sie sich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutzen Sie das Registrierungsformular, um sich zu registrieren oder informieren Sie sich ausführlich über den Registrierungsvorgang. Falls Sie sich bereits zu einem früheren Zeitpunkt registriert haben, können Sie sich hier anmelden.
Dieser Beitrag wurde bereits 3 mal editiert, zuletzt von »sanni« (22. Dezember 2013, 11:53)
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Dom« (28. Februar 2014, 12:37)
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Tl866cs« (16. Dezember 2014, 01:20)
I have ordered 2 of the UL94V-0 boards and 2 of the 29f032b chips. I will be constructing the described adapter to use with the TL866CS and I have a couple of questions.
The first test (while I wait for my order from BuyIcNow) is to remove the 32mb chip from a Spider-man Separation Anxiety cartridge and attempt to read it using the TL866CS using the 29f033 chip type. There is no #RESET pin so should I just leave this unconnected on the TL866CS?
Yes, leave it unconnected.![]()
Next, I will program the 29f032b using the data from the Spider-Man ROM and try it out. I saw that you connected the #RESET pin from the ULV94V-0 to the TL866CS by soldering a wire onto the #RESET pad. Is this necessary for the programmer to work? (It's ok if it is) What functions do not work if the #RESET is not connected but is left high. (If the #RESET is not connected wouldn't you just be able to reprogram the 29f032b and plug it into a socket on the cartridge without soldering anything?)
By far... I did not mention any difference by connecting the reset or by leaving it unconnected(29f016D or 29f033C I don't use 29f32b very often). However as you can see...
[SNES] TSOP-to-TL866 (GQ-4X) Adapter
I also use this PIN with my adapter.
Finally, I have seen differing opinions about whether to use SMD 10 ohm resistors on the 3 resistor locations or just solder blobs as jumpers. What is your opinion and what did you do?
I never used resistors. A blob of solder or a thin wire is far enough.
By the way I was thrilled to find your post about using the TL866CS to perform the programming!
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »OMEGA-RED« (16. Dezember 2014, 13:28)